CCNA 3 Final Exam Answers version v – % Full, CCNA v5. v The new switch has a VTP revision number of 4. CCNA v Routing and Switching Exam Answers , Free CCNA Study Guide, Tutorials, Labs, Practice Exams. CCNA Security, , v CCNA 2 v Capitulo 4 Examen Online en Español Cisco CCNA 1 Capitulo 4 Examen Pregunta 13 Cisco CCNA2 v Capítulo 3 Examen Pregunta
|Published (Last):||15 October 2014|
|PDF File Size:||5.32 Mb|
|ePub File Size:||14.75 Mb|
|Price:||Free* [*Free Regsitration Required]|
Which value determines if a switch becomes the central point of reference in the spanning tree topology?
It descaggar broadcast packets to a single VLAN. There is a native VLAN mismatch. Which hosts will receive the collision jamming signal? What will be the result of the student making this connection?
CCNA 3 Final Exam V Answers
Relocate the APs closer to each other. It is configured in VTP server mode. The VTP domain has been configured as shown in the exhibit.
The switch traffic is exceeding available frame buffers. When forwarding a frame to the device with address v40 All trunk links are operational and all VLANs are allowed on all trunk links. June 19, at 5: What are two benefits of the IEEE Whenever an inter-switch link fails, the network takes nearly a minute to completely converge.
The port will transition immediately into forwarding state. What will fix the problem? Other PCs on the switch can consistently ping the default gateway. The clear switching-tables command will remove statically configured entries.
A backup configuration from a TFTP server cannot be copied directly into the startup-config. SW1 is configured with native vlan10 so to change it to would enable the connectivity for hosts on vlan Which two steps should the administrator perform to achieve this?
CCNA 3 Final Exam V4.0 Answers
Module 6 – IT, Sligo. It prevents loops in a switched network with redundant paths. November 30, at 8: The clear mac-address-table command will remove statically and dynamically configured table entries.
December 8, at curricuka Networking for Home and Small Businesses Version 4. All inter-switch links that are shown are trunks. However, hosts B and D cannot ping each other.
Examenes Cisco CCNA v en Español
September 26, at 6: Which IP address should be assigned to this new host? The port will transition into blocking state and immediately transition through the listening and learning states. The port will transition into blocking state and then immediately into forwarding state.
Hosts B and D are configured with IP addresses from different subnets. Attach the web server to a router and configure inter-VLAN routing. Default native vlan is vlan1. STP is automatically enabled. This includes implementation and verification of connections to remote sites in a WAN. Freeware for Solaris Unix sunfreeware. How does SW1 manage traffic coming from Host A? While configuring a new switch, a network administrator configures the switch as an HTTP server. The answer should be: The switch port is able to trunk if the remote switch port is set to desirable.
Change the channel on AP-B to 6 or On the basis of the outputs that are provided, which group of users will be able to communicate with the users on VLAN 10 on SW1?
Host A maintains connectivity to all members of VLAN 10, because it is connected to the same physical network.
Configure the VTP mode of the switch to transparent. Download The Cisco Report Today! Click to my CV. The link between the switches is up but not trunked. Only the device with MAC address