Add Attachments to Content Item ‘ASTM D Glass Transition Temperature ( DMA Tg) of Polymer Matrix Composites by Dynamic Mechanical Analysis (DMA) . ASTM D Glass Transition Temperature (DMA Tg) of Polymer ASTM D has become a widely used test standard in many companies due to. ASTM D用DMA测试Tg_能源/化工_工程科技_专业资料。Designation: D – 07?1 Standard Test Method for Glass Transition.
|Published (Last):||22 September 2005|
|PDF File Size:||12.50 Mb|
|ePub File Size:||10.1 Mb|
|Price:||Free* [*Free Regsitration Required]|
The DMA Tg is determined to be the intersection of two tangent lines from the storage modulus by this test method.
Interpretation of Results In this example the transition is less clear than the thermogram of Fig. Weigh the specimen to the nearest milligram 0.
For example, a linear plot scale will result in a lower value of DMA Tg. Historical Version s – view previous versions of standard. Therefore, it is recommended that the test specimens should be weighed before and after DMA Tg testing to asfm the moisture change in the specimen resulting from the DMA Tg test.
Other materials, such as neat resin, may require non-standard deviations from this test method to achieve meaningful d028. Depending on the analyzer, typical specimen size can range from 56 6 4 3 12 6 1 3 2.
It is possible that more than one transition exists, but this should be con? Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. Other loading modes such 7d028 tensile, torsion or shear may produce different test results.
If you feel that your comments have not received a fair hearing you should make your views known to the ASTM Committee on Standards, at the address shown below. A non-standard DMA Tg de? This temperature is designated as TB. It is standard that one of the major? If the testing is part of a designed experiment, other sampling techniques may be used if described in the test plan. The conditioned specimens shall be tested within 30 minutes after removal from the conditioning chamber, or stored in sealed MIL-PRF or equivalent aluminized bag until test.
It is widely known that heat transfer limitations are more pronounced in DMA apparatus compared to other thermal analysis techniques, such as differential scanning calorimetry DSC and thermomechanical analysis TMA. Laminate edges or other irregularities created in the laminate by mold or bagging techniques should be avoided. Any deviations from the standard orientation shall be reported and the test results noted as non-standard.
This could indicate that the sample was taken from a defective portion of the laminate.
ASTM D7028 – 07(2015)
Generally, the specimen should be centered between the clamp faces and be parallel to the base of the instrument. If a non-standard frequency, or the resonance mode, is used, the non-standard approach shall be described in the report and the test result recorded as non-standard.
Instrumentation manufacturer recommendations should be followed. Other materials, such as neat resin, may require non-standard deviations from this test method to achieve meaningful results. ASTM E This temperature is designated as TA.
These values indicate that r7028 material factors did not have a signi? Link to Active This link will always route to the current Active version of the standard.
A change in heating rate will affect the glass transition temperature result; the standard heating rate is the best available compromise for comparing DMA D70228 results of dry and wet laminates. If the two tangent lines are constructed from temperatures too close to the transition, the intersection is depicted as shown in Fig. D Terminology for Plastics: A non-standard specimen con?
The values given in parentheses are non-standard mathematical conversions to common units that are provided for information only.