ASTM C1090 PDF

Measuring Changes in Height of Cylindrical Specimens of Hydraulic-Cement Grout. ASTM C Standard Test Method for Measuring Changes in Height of Cylindrical Specimens of Hydraulic-Cement Grout. ASTM C/CM: Standard Test Method for Measuring Changes in Height of Cylindrical Specimens of Hydraulic-Cement Grout.

Author: Nami Zolobei
Country: Germany
Language: English (Spanish)
Genre: History
Published (Last): 21 February 2005
Pages: 324
PDF File Size: 10.18 Mb
ePub File Size: 8.80 Mb
ISBN: 960-4-40471-938-4
Downloads: 96672
Price: Free* [*Free Regsitration Required]
Uploader: Vutaxe

I married on 30 th June now having one b Though not recommended by the ASTM standards, and in order qstm provide the lowest friction possible, an acetate sheet was used in between the test specimen and the mold.

The height change results in both test methods are expressed in terms of percentage increase or decrease of the original specimen height. The laser approach has been compared with the original setup, and similar results were obtained. Combining values from the two systems may result in non-conformance with the standard.

[email protected]: Testing of shrinkage for concrete – grout.

The height change of a 3-inch mm -diameter by 6-inch mm -tall cylindrical specimen was measured in xstm with ASTM C Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. Some values have only SI units because the inch-pound equivalents are not used in practice.

  KNJIGA POSTANJA PDF

Historical Version s – view previous versions of standard. Sieve size is identified by its standard designation in Specification E The glass plate c1009 removed from the top of the test specimen after 24 h. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

In both test methods, there is always a certain degree of friction between the specimen’s sides and the inner surface of the metallic mold. Testing of shrinkage for concrete – grout.

For cementitious grouts, saturate the surface up to SSD. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other.

These test methods v1090 procedures for assessing the adhesion of coating films to metallic substrates by applying and removing pressure-s Newer Post Older Post Home. The degree of restraint varies with the mixture viscosity and degree of hardening.

An exception is made when the options described in the section on test conditions are exercised. This thickness was then added to the four-reading initial measurement.

  GARLOCK 3545 PDF

ASTM International – Standard References for ASTM C / CM – 15

Link to Active This link will always route to the current Active version of the standard. After removal, the thickness of the glass plate was measured with a caliper at the points of contact between the glass plate and the micrometer.

Two cylindrical specimens with the same dimensions as those used for the ASTM C test method were prepared in which the change in height was measured at four points on the top surface of the specimens using a micrometer in accordance with ASTM C at 1, 3, 7, 14, and 28 d see figure This approach provided more simplicity in the execution of the test, rather than using a projector lamp, magnifying lens, and indicator charts as described in ASTM C see figure The alternative designation given in parentheses is for information only and does not represent a different standard sieve size.